|
Manufactured with cross linked Isopoli foam
Suitable for: robust details - new build
E1 - new build • E1 - material change of use
• Conversions
• Refurbishments
• New build
• May also be installed in conjunction with underfloor
heating systems (see data sheet)
Isocheck Shallow Batten system is designed to reduce sound transmission through a level concrete structural sub-floor.
Isocheck Shallow Batten consists of 8mm Isopoli bonded to a FSC - certificated softwood batten. A range of batten sizes are available to special order. When installed as part of a complete party floor construction it enables a concrete floor to meet the sound transmission standards of ADE 2003 (amended 2004).
Should the requirement be for a batten height other than that specified on this page please contact us for further technical advice and suitability.
Applications
To be used over concrete floors for conversions, refurbishments or new build (to hide services or accommodate underfloor heating beneath the floor) with a new ceiling as illustrated.
Performance (on the two Robust Detail constructions illustrated)
Treated floor meets with the Robust Detail descriptive FFT3, typically within Robust Details E-FC-1, E-FC-2, E-FC-7 and E-FS-1. Two typical alternative constructions are shown above.
Product data
| Overall batten size: |
1800mm x 45mm x 54mm |
| Resilient layer thickness: |
8mm |
| Resilient layer: |
Cross linked Isopoli foam |
* alternative size battens are available to special order.
Specification
The acoustic floor shall be:
Isocheck Shallow Batten system, manufactured by Isomass Ltd. St Johns Innovation Centre, Cowley Road, Cambridge, CB4 0WS and installed in accordance with manufacturer’s instructions / recommendations.
Installation
Lay Isocheck Shallow Batten resilient layer side down, at 400mm max. centres for 18mm chipboard flooring or 500mm max. centres for 22mm chipboard flooring.
Apply Isocheck Acoustic Angled Flanking Band on the edges of the chipboard just before they are pushed against the perimeter walls to isolate the board from the wall.
Apply Isocheck adhesive to all tongued and grooved panel joints.
Install skirting and trim off excess Flanking Band.
Full installation instructions for Isocheck Shallow Batten are available upon request. These must be used in conjunction with this booklet when laying the Isocheck Shallow Batten floating floor system.
May also be installed in conjunction with underfloor heating systems. |
