Isocheck Re-Mat high load Isolating Strips are designed to be installed beneath blockwork walls to isolate the wall from the concrete floor and reduce structure borne noise.
The Isolating Strips are composed of a rubber crumb which provides exceptional stability and minimal creep.
Isocheck Re-Mat high load Isolating Strips offer long term performance without collapse or “bottoming” out under high load points. They are available in a wide range of thicknesses and their slim thicknesses minimises construction heights.
They are:
| Maximum load bearing capacity: Temperature resistance: Static modulus of elasticity: Dynamic modules of elasticity*: Compression set to DIN 53572**: Tensile strength to DIN 53571: Elongation at break to DIN 53571: Tear resistance to DIN 53515: Flammability: | 0.8N/mm² -40°C up to +110°C (Short Term) 2.50 – 5.50N/mm² 3.0 – 8.8N/mm² Approx. 5.90% Min. 0.90N/mm² Min. 85% Min. 0.8N/mm Class B2 |
*Figures dependant upon load and natural frequency and material thickness
**Measured 30 minutes after decompression with 50% deformation @ 23°C after 72 hours.
| Thicknesses: Standard widths*: 0 Roll length: 0 Composition: | 0 5mm thick 6mm thick 5mm thick 6mm thick | 5mm thick & 6mm thick options 50, 75, 100, 120, 150, 190, & 200mm 100, 120, 150, 180, 200 & 240mm 1.15m 1.25m Rubber crumb |
* other widths available upon request
Isocheck Re-Mat Isolation Strip, supplied by Isomass Ltd. Unit 14 Papworth Business Park, Stirling Way, Papworth Everard, Cambridgeshire CB23 3GY and installed in accordance with manufacturer’s instructions / recommendations.
Ensure the base floor is dry, clean (free of dirt and dust) and flat. Re-Mat Isolation Strip can be loose laid or bonded to the base floor using an appropriate adhesive in accordance with the adhesive manufacturer’s instructions. Contact Isomass for a list of recommended adhesives.
Note: it is the sole responsibility of the installer to select bonded or loose laid for the Isolating Strip.
Ensure that a width of strip is used which takes into account the thickness of the blockwork and any cladding/finishes. Any surplus material should be trimmed with a builder’s knife and removed.
Full installation instructions are available and must be used in conjunction when laying this floor system.
Re-Mat Isolation Strip in conjunction with screed over Isocheck Screedcheck XL5 or XL9 (right).
Re-Mat Isolation Strip in conjunction with Isocheck Cradle with 18mm chipboard floor (right).
